Tint Installation Instructions
- Thoroughly wash your hands.
- Roll film in opposite direction of packing to flatten it out and make it easier to work with. Waves and light creases are completely normal and will NOT be visible when applied.
- Wash and dry the area where the tint will be applied.
- Remove the tint from the backing and place it centered over the area starting from one edge.
- work the air out from one side to the other.
- If you get to the end and there is not enough film to cover the area or too much left over, have a look at where you started and see if you can start at a different spot to fix the issue.
- If needed, peel the film off and start over till you get it right.
- If the panel is not flat, you will need to work the film around any curves with your fingers. simply press the film along the curves and it will stick.