This product is designed to be installed without the use of any liquid. The material is repositionable and can be removed, reapplied, and stretched for proper fitment.

1. Thoroughly wash your hands.
2. Roll film in opposite direction of packing to flatten it out and make it easier to work with. Waves and light creases are completely normal and will NOT be visible when applied.
3. Wipe the area and all surrounding areas clean of any dust wax or silicone.
4. Remove the vinyl from the backing and roughly align it on the panel were it is to be applied. Be very careful not to tear or excessively stretch the film while repositioning it.
5. Align one of the areas to the best of your ability, with that area aligned you can now lift the film from the other areas and begin to align them.
6. Use your fingers to gently lock the film in to place with medium pressure.
7. If there are any contours on your panel, do those at the very end. You will need a heat gun or a blow dryer to warm the film making it more pliable. Focus on the edges first to ensure a proper fit.
8. If you get bubbles or creases, lift the film and warm the film. The crease or bubble will disappear and you can re-apply.
9. If needed, peel the film off and start over till you get it right.
10. If the panel is not flat, you will need to work the film around any curves with your fingers. simply press the film along the curves and it will stick.